Quick Bond Adhesive
Description
Quick Bond is a polymer based adhesive for use with EIF systems applied over most substrates. Quick Bond provides a strong bond between foam and substrate.
Color
Light beige
Container
45-pounds net weight / 5-gallon pail
Use
Quick Bond is used as an adhesive for foam to substrate as well as foam to foam.
Adhesion
Good adhesion to concrete, cement board substrates, block, brick, expanded polystyrene and polyisocyanurate foams.
Coverage
Approximately 130 square feet per container for flat substrates.
Drying Time
12-24 hours, depending on climate. Drying time can be greatly affected by temperature and humidity.
Storage
Protect from freezing. Store in a cool, dry area tightly sealed. Recommended storage temperature between 40-90 F.
Clean-up
Water soluble when wet.
Shelf Life
One year, if protected from direct sunlight and freezing temperatures.
Limitations
- Ambient and surface temperatures must be above 40 F during application and drying period.
- Quick Bond should never be used on horizontal surfaces.
Surface Preparation
Substrate must be clean, dry, and free from all loose or foreign materials prior to application of Quick Bond.
Application
Quick Bond is usually applied to the foam with stainless steel masonry trowels notched 3/8" wide by 1/2" deep every 1 1/2". It can also be applied with a regular steel trowel, using the "ribbon and dab" method. The foam should then be applied to the substrate by pushing the foam on and sliding it into place such that no gaps exist between foam pieces.
|
